Morristown Public Water System

Who runs it

EPA's record says Morristown Public Water System has 135 service connections and serves 315 people.

EPA classes it as a community water system, one that serves the same residents all year.

Its office telephone on EPA's record is 740-484-1566.

Source: EPA Safe Drinking Water Information System (SDWIS), water system record.

How the water is treated

Morristown Public Water System buys water that Belmont Co. Sanitary District 3 treats first, so the steps that count are the seller's. EPA's treatment table registers these steps for Belmont Co. Sanitary District 3: corrosion control, chlorine disinfection, fluoridation, ion-exchange softening, and sand or media filtration.

Morristown Public Water System adds nothing of its own on that table.

The list is what each system registered with EPA for treatment plants EPA still shows as active, and it can lag a plant upgrade.

Source: EPA Safe Drinking Water Information System (SDWIS) treatment table (EPA Envirofacts, pulled September 2026).

Violations

EPA's record shows no health-based violations for Morristown Public Water System since 2015.

EPA logs 6 violations of any kind since 2020: 1 for required testing that was missed or reported late; 5 for a report, record or notice that was missing, late or incomplete (the yearly water quality report, a public notice, lead line records).

Source: EPA Safe Drinking Water Information System (SDWIS) violation records: health-based violations with compliance periods beginning in 2015 or later, all violations from 2020 or later (EPA Envirofacts, pulled September 2026).

Lead and copper at the tap

In the sampling period ending December 2023, the 90th-percentile lead result at Morristown Public Water System was 0 ppb, under both the current 15 ppb action level and the 10 ppb level that applies from 2027. A result of 0 means at least nine in ten of the homes sampled had no lead detected.

EPA has 3 sampling periods on file for Morristown Public Water System since 2016, the first ending in 2017; no period was above 10 ppb.

Every water system has to inventory its service lines, the pipes from the main to each building. In the inventory Morristown Public Water System sent EPA, 130 lines are counted.

Systems sample taps in the homes most likely to have lead pipes or solder. The 90th-percentile result is the level nine in ten of the sampled homes were at or below. Lead comes mostly from service lines and house plumbing, not the source water, so a low result for the system does not clear an old house.

EPA's dashboard status for this inventory: reported all required service line types.

Source: EPA Safe Drinking Water Information System (SDWIS) lead and copper 90th-percentile results (EPA Envirofacts), sampling periods ending 2016 or later; EPA's service line inventory dashboard, Ohio's 2026 Q2 submission.

PFAS

The water Morristown Public Water System buys is treated by Belmont Co. Sanitary District 3, so the results below are Belmont Co. Sanitary District 3's.

EPA's fifth national round of testing (UCMR 5) took 3 samples of the water entering the pipes of Belmont Co. Sanitary District 3 in 2023 and measured 29 PFAS. No PFAS was detected, PFOA and PFOS (federal limit 4 ng/L each) among them.

Ohio EPA's own statewide sampling tested 1 plant of Belmont Co. Sanitary District 3 (latest sample June 2020). Not one of the six PFAS tested (PFOA, PFOS, PFHxS, PFNA, GenX and PFBS) was detected.

Ohio EPA's current sampling status map lists 2 plants of Belmont Co. Sanitary District 3 as sampled, most recently February 2026.

PFAS are the 'forever chemicals' from firefighting foam, plating shops and non-stick coatings. Results are for water leaving the plant, not your tap.

Source: EPA UCMR 5 occurrence data (final release, August 2026); Ohio EPA statewide PFAS sampling, 2019 to 2021, and its sampling status map.

Disinfection byproducts

Chlorine that disinfects water also reacts with organic matter to form byproducts. Two groups have federal limits: total trihalomethanes (TTHM, 80 µg/L) and five haloacetic acids (HAA5, 60 µg/L), judged on running yearly averages at each sampling site.

For TTHM, the average of Morristown Public Water System's samples in 2019, the last year it was sampled, was 48 µg/L. The worst yearly average was 54.9 µg/L and the highest single sample was 54.9 µg/L, from 5 samples taken from 2015 to 2019.

For HAA5, the average in the last year sampled was 11.1 µg/L. The worst yearly average was 11.1 µg/L and the highest single sample was 11.1 µg/L, from 5 samples.

A yearly average of 0 means nothing was detected in that year's samples. EPA's file stops at 2019; Ohio EPA's Drinking Water Watch has newer results.

Source: EPA Six-Year Review 4 compliance monitoring data, 2012 to 2019, distribution-system samples (non-detects counted as zero).

Nitrate, arsenic and radioactivity

The water Morristown Public Water System buys is treated by Belmont Co. Sanitary District 3, so the results below are Belmont Co. Sanitary District 3's.

Nitrate: the highest of 7 samples was 1.86 mg/L (as nitrogen) in 2017; in 2019, the last year sampled, the highest was 1.03 mg/L. No sample was over the limit of 10 mg/L. Nitrate above 10 is unsafe for infants.

Arsenic was not detected in 2 samples (limit 10 µg/L).

Measured in finished water: at the plant's entry points and in the distribution system; raw well and intake samples are left out. Non-detects count as zero.

Source: EPA Six-Year Review 4 compliance monitoring data, 2012 to 2019, finished water of Belmont Co. Sanitary District 3.

Solvents and fuels

The water Morristown Public Water System buys is treated by Belmont Co. Sanitary District 3, so the results below are Belmont Co. Sanitary District 3's.

EPA's file holds results for all six solvent and fuel compounds it checked. Benzene, carbon tetrachloride, 1,2-dichloroethane, trichloroethylene, tetrachloroethylene, and vinyl chloride were not detected in 6 samples each.

"Not detected" means the lab's result was below what its method can measure, not that the compound is absent. Non-detects count as zero in the highest-result column.

Source: EPA Six-Year Review 4 compliance monitoring data, 2012 to 2019, finished water of Belmont Co. Sanitary District 3.

Farm chemicals and metals

The water Morristown Public Water System buys is treated by Belmont Co. Sanitary District 3, so the results below are Belmont Co. Sanitary District 3's.

EPA's file holds results for 8 of the nine herbicides and metals it checked. Detected: barium in 1 of 2 samples, highest 23.5 µg/L (limit 2,000). Not detected: atrazine, alachlor, chromium, cadmium, mercury, selenium, and thallium, in 2 samples each.

Non-detects count as zero in the highest-result column.

Source: EPA Six-Year Review 4 compliance monitoring data, 2012 to 2019, finished water of Belmont Co. Sanitary District 3.

Bacteria in the pipes

From 2012 to 2019, 0 of 96 routine total coliform samples taken in the distribution system at Morristown Public Water System tested positive (0%); in 2019, the last year on file, 0 of 12 did.

A positive coliform test is a warning sign, not a violation by itself. E. coli is a sign that human or animal waste may have reached the water. Coliform counts are routine samples only; E. coli counts include repeat samples.

Source: EPA Six-Year Review 4 compliance monitoring data, 2012 to 2019, distribution-system presence/absence tests for total coliform and E. coli.

Fluoride

The Ohio Department of Health's report to the CDC (My Water's Fluoride) says Morristown Public Water System buys its water from Belmont Co. Sanitary District 3, a system that adjusts the fluoride level to the recommended level for preventing tooth decay.

EPA's treatment table lists fluoridation among the steps at Belmont Co. Sanitary District 3, which treats the water Morristown Public Water System buys.

Measured fluoride: 1 mg/L on average leaving the plants of Belmont Co. Sanitary District 3, which supplies Morristown Public Water System, in 2017 (in the range dentists aim for); samples ran from 0.98 to 1 mg/L across 2 samples in 2012 to 2019.

The recommended level for preventing tooth decay is 0.7 mg/L; the federal limit is 4 mg/L. The treatment list is what each system registered with EPA and can lag a plant upgrade.

Source: CDC My Water's Fluoride (fluoridation status as reported by the Ohio Department of Health, fetched September 2026); EPA Safe Drinking Water Information System (SDWIS) treatment table; EPA Six-Year Review 4 compliance monitoring data, 2012 to 2019, entry-point fluoride samples.

Lithium

Lithium was not detected in 2 UCMR 5 samples at Belmont Co. Sanitary District 3, which supplies Morristown Public Water System, last sampled in 2023 (the method reports from 9 µg/L).

Lithium is not regulated. EPA's draft health reference level is 10 µg/L, and it occurs naturally in deep groundwater, so well systems in the northwest run highest.

Source: EPA UCMR 5 occurrence data (final release, August 2026), samples from 2023 to 2025.

How well the service area is mapped

EPA estimated the service area of Morristown Public Water System with a computer model rather than drawing it from the utility's map, so its edges are approximate.

Source: EPA Service Area Boundaries; resident estimate by this atlas from ZIP-code overlap.